Front USB connector
assembly
Spring clips
8. Place the bottom edge of the housing into the bottom of the opening in the chassis; then, tilt the top of
the housing into position until it clicks into place.
9. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
10. Reroute and connect the front USB cable to the front USB connector on the system board (see
"System-board internal connectors" on page 25
System x3100 M4 Installation and Service Guide
208
Front USB housing
Front USB housing
for the location of the front USB connector).