Lenovo System x3100 M4 Installation And Service Manual page 170

Note: If you are installing Intel Ethernet Quad Port Server Adapter I340-T4 (part number 49Y4240), you can
only install the adaptor in slot 1, slot 2, or slot 3.
To install a replacement ServeRAID adapter on 4U server models with non-hot-swap power supplies,
complete the following steps. For the 5U server model with hot-swap power supplies (Model name: 2582-
F4x), please see the next sub-section.
Note: If possible, back up or record your RAID configuration information before replacing the adapter. See
the documentation for your RAID adapter for information and instructions. Documentation for ServeRAID
adapters can be downloaded from
1. Read the safety information in
2. Check the instructions that come with the adapter for any requirements, restrictions, or cabling
instructions. It might be easier to route cables before you install the adapter.
3. Follow the instructions that come with the adapter to set jumpers or switches, if any.
4. Touch the static-protective package that contains the adapter to any unpainted metal surface on the
server. Then, remove the adapter from the static-protective package. Avoid touching the components
and gold-edge connectors on the adapter.
5. Turn off the server and all peripheral devices; then, disconnect the power cords and all external cables.
6. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
7. Remove the side cover (see
8. Remove the air duct.
9. Follow the cabling instructions, if any, that come with the adapter. Route the adapter cables before you
install the adapter.
10. Follow the instructions that come with the adapter to set jumpers or switches, if any.
11. Lift the end of the rear adapter retention bracket till the tab disengages the hole on the chassis.
12. Rotate the rear adapter retention bracket upward to remove it from the chassis.
13. Remove the screw that secures the expansion-slot cover to the chassis. Store the expansion-slot cover
and screw in a safe place for future use.
Note: Expansion-slot covers must be installed on all vacant slots. This maintains the electronic
emissions standards of the server and ensures proper ventilation of server components.
14. Touch the static-protective package that contains the adapter to any unpainted metal surface on the
server. Then, remove the adapter from the static-protective package. Avoid touching the components
and gold-edge connectors on the adapter.
System x3100 M4 Installation and Service Guide
156
http://www.lenovo.com/support
"Safety" on page v and
"Removing the side cover" on page
.
"Installation guidelines" on page
145).
30.