Lenovo System x3100 M4 Installation And Service Manual page 65

12. Push the drive into the bay.
Note: A tape drive can only be installed in bay 1 or bay 2
13. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
14. Connect one end of the applicable signal cable into the rear of the drive and make sure that the other
end of this cable is connected into the applicable connector on the system board.
15. Route the signal cable so that it does not block the airflow to the rear of the drives or over the
microprocessor and dual inline memory modules (DIMMs).
If you have other devices to install, do so now. Otherwise, go to
To install a tape drive on the 5U server model with hot-swap power supplies (Model name: 2582-F4x),
complete the following steps. For 4U server models with non-hot-swap power supplies, please see the
above sub-section.
1. Read the safety information in
2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables.
3. Unlock and remove the side cover (see
4. Remove the lower bezel (see
5. Remove the upper bezel (see
6. Touch the static-protective package that contains the drive to any unpainted metal surface on the
server; then, remove the drive from the package and place it on a static-protective surface.
7. Set any jumpers or switches on the drive according to the documentation that comes with the drive.
8. Slide the drive retainer clip to the front to remove it from the drive cage of bay 2; then, snap the drive
retainer clip into the screw holes on the side of the drive.
"Safety" on page v and
"Removing the side cover" on page
"Removing the lower bezel" on page
"Removing the upper bezel" on page
"Completing the installation" on page
"Installation guidelines" on page
32).
35).
36).
.
Chapter 2
70.
30.
Installing optional devices
51