Mitsubishi MELSEC QD75P User Manual page 629

15 TROUBLESHOOTING
Related buffer memory
address
Axis 1 Axis 2 Axis 3 Axis 4
0 150 300 450
1 151 301 451
2 152 302 452
3 153 303 453
4 154 304 454
5 155 305 455
6 156 306 456
7 157 307 457
10 160 310 460
11 161 311 461
12 162 312 462
13 163 313 463
14 164 314 464
15 165 315 465
17 167 317 467
18 168 318 468
19 169 319 469
Set range
(Setting with sequence program)
0, 1, 2, 3
1 to 65535
1 to 65535
1, 10, 100, 1000
0, 1, 2, 3
0, 1
0 to 1000000 [pulse/s]
0 to 2000000000 [mm/min or others]
QD75P :
1 to 200000 [pulse/s]
1 to 2000000000
[mm/min or another]
QD75D :
1 to 1000000 [pulse/s]
1 to 2000000000
[mm/min or another]
1 to 8388608
1 to 8388608
0 to 255
• [mm] [inch] [pulse]
–2147483648 to 2147483647
• [degree] 0 to 35999999
15 - 25
Get other manuals https://www.bkmanuals.com
Remedy
With the setting brought into the setting range, turn the
PLC READY signal [Y0] from OFF to ON.
Set the bias speed to not more than the speed limit
value.
With the setting brought into the setting range, turn the
PLC READY signal [Y0] from OFF to ON.
• The value converted into the frequency should not
exceed the maximum output frequency ("maximum
output pulse" in Section 3.1) of the module.
• Set a value which is not less than the OPR speed.
• With the setting brought into the setting range, turn
the PLC READY signal [Y0] from OFF to ON.
With the setting brought into the setting range, turn the
PLC READY signal [Y0] from OFF to ON.
Set the value converted into the pulse number using
"the movement amount per pulse" to less than 256
pulses. (Refer to Section 12.3.1)
• Bring the setting into the setting range.
• In a unit other than degree, set the setting so that the
lower limit value is smaller than the upper limit value.
MELSEC-Q