Table of Contents
Advertisement
7 MEMORY CONFIGURATION AND DATA PROCESS
(1) Transmitting data when power is turned ON or PLC CPU is reset
(2) Transmitting data with TO command from PLC CPU (
(3) Validate parameters when PLC READY signal [Y0] changes from
(4) Accessing with FROM command from PLC CPU (
(
)
When the power is turned ON or the PLC CPU is reset, the "parameters",
"positioning data" and "block start data" stored (backed up) in the flash ROM is
transmitted to the buffer memory.
The parameters or data is written from the PLC CPU to the buffer memory using
the TO command. At this time, when the "parameter area (b)
data (No. 1 to 600)", "block start data (No. 7000 to 7004)", "control data" and
"PLC CPU memo area" are written into the buffer memory with the TO command,
it is simultaneously valid.
1 Parameter area (b) ...... Parameters validated simultaneously with the writing
OFF to ON
When the PLC READY signal [Y0] changes from OFF to ON, the data stored in
the buffer memory's "parameter area (a)
Pr.5
For
, however, only the data obtained first after the PLC READY signal [Y0]
changes from OFF to ON when the power is turned ON or PLC CPU is reset
becomes validate.
(Refer to Section 5.2 "List of parameters" for details.)
2: Parameter area (a) .... Parameters validated when PLC READY signal [Y0]
POINT
The setting values of the parameters that correspond to parameter area (b) are
valid when written into the buffer memory with the TO command.
However, the setting values of the parameters that correspond to parameter area
(a) are not validated until the PLC READY signal [Y0] changes from OFF to ON.
The data is read from the buffer memory to the PLC CPU using the FROM
command.
Get other manuals https://www.bkmanuals.com
to the buffer memory with the TO command.
Pr.8
Pr.10
Pr.25
(
to
,
2" is validated.
changes from OFF to ON.
Pr.1
Pr.7
Pr.11
(
to
,
Pr.57
to
,
Pr.150
)
7 - 7
MELSEC-Q
)
1", "positioning
Pr.42
to
)
Pr.24
Pr.43
to
,
)
Advertisement
Table of Contents
