Led Indicator - ICP DAS USA iWSN-110X Series Quick Start Manual

4

LED indicator

The module provides one LED indicator. The table below will show the LED status.
Indicators
STA
Status
500ms
Illegal Node ID, please set the Node ID
Blink
to 1~31, and then power on.
continuous
Low battery power.
1. Please confirm whether the CT is
Blink once
2. If have any questions, please
Component status is abnormal.
1. Please confirm whether the audio
Blink twice
2. If have any questions, please
Unable to confirm sensor type.
1. Please confirm whether the audio
Blink three
times
2. If have any questions, please
Instructions
lock into the "CT" pin of the module
and bucked to the wire for charging.
contact technology support.
line of "Ext_Bus" is fully inserted
and the module is power off. And
power on after press "Wake" and
"Boot" buttons for 5 seconds.
contact technology support.
line of "Ext_Bus" is fully inserted
and the module is power off. And
power on after press "Wake" and
"Boot" buttons for 5 seconds.
contact technology support.
P6