Checking The Final Gear Oil Level - Yamaha FJR13AG Service Manual

11.Fill:
• Cooling system
(with the specified amount of the recom-
mended coolant)
Recommended antifreeze
High-quality ethylene glycol anti-
freeze containing corrosion in-
hibitors for aluminum engines
Mixing ratio
1:1 (antifreeze:water)
Radiator (including all routes)
2.60 L (2.75 US qt, 2.29 Imp.qt)
Coolant reservoir (up to the
maximum level mark)
0.25 L (0.26 US qt, 0.22 Imp.qt)
Handling notes for coolant
Coolant is potentially harmful and should be
handled with special care.
EWA13040
WARNING
• If coolant splashes in your eyes, thorough-
ly wash them with water and consult a doc-
tor.
• If coolant splashes on your clothes, quickly
wash it away with water and then with soap
and water.
• If coolant is swallowed, induce vomiting
and get immediate medical attention.
ECA13481
NOTICE
• Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is
used instead of coolant, check, and if nec-
essary, correct the antifreeze concentra-
tion of the coolant.
• Use only distilled water. However, if dis-
tilled water is not available, soft water may
be used.
• If coolant comes into contact with painted
surfaces, immediately wash them with wa-
ter.
• Do not mix different types of antifreeze.
12.Install:
• Radiator cap
13.Fill:
• Coolant reservoir
(with the recommended coolant to the maxi-
mum level mark "a")
PERIODIC MAINTENANCE
14.Install:
• Coolant reservoir cap
15.Start the engine, warm it up for several min-
utes, and then stop it.
16.Check:
• Coolant level
Refer to "CHECKING THE COOLANT LEV-
EL" on page 3-27.
TIP
Before checking the coolant level, wait a few
minutes until the coolant has settled.
17.Install:
• Side cowlings
Refer to "GENERAL CHASSIS (2)" on page
4-5.
EAS30859

CHECKING THE FINAL GEAR OIL LEVEL

1. Stand the vehicle on a level surface.
TIP
• Place the vehicle on the centerstand.
• Make sure the vehicle is upright.
2. Remove:
• Final gear oil filler bolt "1"
(along with the gasket "2")
3. Check:
• Final gear oil level
The final gear oil level should be to the bot-
tom brim "3" of the filler hole.
Below the bottom brim → Add the recom-
mended final gear oil to the proper level.
1
2
3-30
a
3