Installing The Rear Fender Assembly - Yamaha FJR13AG Service Manual

REAR SHOCK ABSORBER ASSEMBLY (FJR13ESG)
TIP
• Make sure that the oil seals do not protrude
past the edges of the relay arm.
• When installing the oil seals to the relay arm,
face the character stamp of the oil seals out-
side.
a
4
2
b
3
A
c
d
3
1
e
A. Left side
B. Right side
5. Install:
• Relay arm "1"
• Connecting arms "2"
TIP
• Make sure that the embossed mark "1MD" on
the relay arm faces to the left.
• Make sure that the embossed mark "1MD" on
each connecting arm faces outward.
2
1
a
1
4
2
b
3
B
c
d
3
e
4-131
EAS31853
INSTALLING THE REAR FENDER
ASSEMBLY
1. Install the rear fender assembly temporarily.
2. Pass the rear shock absorber assembly step-
ping motor coupler and rear shock absorber
assembly DC motor coupler through the
holes in the DC motor upper cover and rear
fender assembly, and then connect the cou-
plers.
TIP
Move the rear shock absorber assembly slightly,
and then pass the couplers through the holes in
the DC motor upper cover and rear fender as-
sembly.
3. Install the rear shock absorber assembly
bolts "1" washer, and spacers.
Rear shock absorber assembly
bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
4. Place the DC motor upper cover "1" in its orig-
inal position, and then install the quick fasten-
er "2".
1
1
2