Yamaha FJR13AG Service Manual page 255

ECA19290
NOTICE
If the brake pipe flare nut does not turn easi-
ly, replace the hydraulic unit, brake pipes,
and related parts as a set.
TIP
• First tighten the brake pipe flare nut, then the
brake hose holder bolt.
• Make sure that the brake pipe is parallel to the
proportioning valve as shown in the illustration.
• Do not bend the brake pipe when tightening
the brake pipe flare nuts.
1
3
2
11.Install:
• Metering valve "1"
• Brake pipe (metering valve to right front brake
caliper) "2"
• Brake pipe (hydraulic unit to metering valve)
"3"
• Gaskets
New
• Brake pipe union bolts
TIP
Temporarily install the metering valve and brake
pipes.
12.Tighten:
• Brake pipe flare nut "4"
• Metering valve bolts "5"
• Brake pipe union bolts "6"
ABS (ANTI-LOCK BRAKE SYSTEM)
ECA19290
NOTICE
If the brake pipe flare nut does not turn easi-
ly, replace the hydraulic unit, brake pipes,
and related parts as a set.
TIP
• First tighten the brake pipe flare nut and meter-
ing valve bolts, then the brake pipe union bolts.
• When tightening the brake pipes onto the me-
tering valve, make sure that the brake pipes
touch the projections "a" on the metering valve.
4
1
4
13.Fill:
• Brake master cylinder reservoir
• Brake fluid reservoir
(with the specified amount of the specified
brake fluid)
EWA13090
WARNING
• Use only the designated brake fluid. Other
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor
brake performance.
• Refill with the same type of brake fluid that
is already in the system. Mixing brake fluids
may result in a harmful chemical reaction,
leading to poor brake performance.
• When refilling, be careful that water does
not enter the brake fluid reservoir. Water
will significantly lower the boiling point of
the brake fluid and could cause vapor lock.
4-82
Brake pipe flare nut
16 Nm (1.6 m·kgf, 12 ft·lbf)
Metering valve bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
Brake pipe union bolt
30 Nm (3.0 m·kgf, 22 ft·lbf)
3
a 1
Specified brake fluid
DOT 4
6
2
a
5