Yamaha FJR13AG Service Manual page 605

Fault code No.
Item
1 Installed condition of O
2 Connection of O
2
pler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
3 Connection of ECU coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
4 Wire harness continuity.
P2195
O sensor: Open circuit detected.
2
sensor. Check for looseness or pinch-
2
ing.
Improperly installed sensor →
Reinstall or replace the sensor.
Improperly connected → Con-
sensor cou-
nect the coupler securely or re-
place the wire harness.
Improperly connected → Con-
nect the coupler securely or re-
place the wire harness.
Open or short circuit → Replace
the wire harness.
Between O
ECU coupler.
gray–gray
pink–pink
Between O
joint coupler.
black–black
Between joint coupler and ECU
coupler.
black/blue–black/blue
Between O
relay unit.
red–red/blue
8-128
FUEL INJECTION SYSTEM
Start the engine and let it idle for
approximately 10 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered" → Go
to item 8 and finish the service.
Condition is "Detected" → Go to
item 2.
Also, delete this fault code,
which has a condition of "De-
tected".
Start the engine and let it idle for
approximately 10 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered" → Go
to item 8 and finish the service.
Condition is "Detected" → Go to
item 3.
Also, delete this fault code,
which has a condition of "De-
tected".
Start the engine and let it idle for
approximately 10 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered" → Go
to item 8 and finish the service.
Condition is "Detected" → Go to
item 4.
Also, delete this fault code,
which has a condition of "De-
tected".
Start the engine and let it idle for
approximately 10 seconds.
sensor coupler and Check the condition of the fault
2
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered" → Go
sensor coupler and
2
to item 8 and finish the service.
Condition is "Detected" → Go to
item 5.
Also, delete this fault code,
which has a condition of "De-
tected".
sensor coupler and
2