Removing The Rear Wheel; Disassembling The Rear Wheel - Yamaha FJR13AG Service Manual

EAS30156

REMOVING THE REAR WHEEL

ECA23440
NOTICE
Keep magnets (including magnetic pick-up
tools, magnetic screwdrivers, etc.) away
from the rear wheel hub "1", otherwise the
wheel sensor rotor equipped in the wheel
hub may be damaged, resulting in improper
performance of the ABS and UBS.
1
1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
TIP
Place the vehicle on the centerstand so that the
rear wheel is elevated.
2. Remove:
• Rear wheel sensor
• Rear wheel axle nut
• Brake torque rod
• Rear wheel axle
• Rear brake caliper
• Rear wheel
• Rear wheel sensor housing
ECA17240
NOTICE
• Do not operate the brake pedal when re-
moving the brake caliper.
• Be sure to remove the rear wheel sensor
before removing the rear wheel sensor
housing, otherwise the sensor could be
damaged.
TIP
Move the rear wheel to the right to separate it
from the final drive assembly.
EAS30158

DISASSEMBLING THE REAR WHEEL

ECA18080
NOTICE
• Keep magnets (including magnetic pick-up
tools, magnetic screwdrivers, etc.) away
from the wheel sensor rotor.
• Do not drop the wheel sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the wheel sensor ro-
tor, wipe it off immediately.
1. Remove:
• Oil seal
• Bearing retainer
• Wheel bearings
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Clean the surface of the rear wheel hub.
b. Remove the oil seal "1" with a flathead screw-
driver.
TIP
To prevent damaging the wheel sensor rotor,
place a rag "2" between the screwdriver and the
surface of the rotor.
c. Loosen the bearing retainer "1" with the hexa-
gon wrench (41) "2".
Hexagon wrench (41)
90890-01525
Hexagon wrench (41)
YM-01525
ECA18160
NOTICE
The bearing retainer has left-handed
threads. To loosen the retainer, turn it clock-
wise.
4-41
REAR WHEEL
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼