Yamaha FJR13AG Service Manual page 490

EAS30494
STARTING CIRCUIT CUT-OFF SYSTEM OPERATION
If the main switch is turned to "ON" and the " " side of the start/engine stop switch is pushed, the starter
motor can only operate if at least one of the following conditions is met:
• The transmission is in neutral (the neutral circuit of the gear position switch is closed).
• The clutch lever is pulled to the handlebar (the clutch switch circuit is closed) and the sidestand is up
(the sidestand switch circuit is closed).
The starting circuit cut-off relay prevents the starter motor from operating when neither of these condi-
tions has been met. In this instance, the starting circuit cut-off relay stays open so current cannot reach
the starter motor. When at least one of the above conditions has been met, the starting circuit cut-off
relay is closed and the engine can be started by pushing the " " side of the start/engine stop switch.
a. WHEN THE TRANSMISSION IS IN
NEUTRAL
b. WHEN THE SIDESTAND IS UP AND THE
CLUTCH LEVER IS PULLED TO THE
HANDLEBAR
1. Battery
2. Main fuse
3. Main switch
4. Ignition fuse
5. Starting circuit cut-off relay
6. Relay unit (diode)
7. Clutch switch
ELECTRIC STARTING SYSTEM
12
11
1
2
3
4
6 6
10
5
6
6
7 a
6
9
8
b
8. Sidestand switch
9. Gear position switch
10. Start/engine stop switch
11. Starter relay
12. Starter motor
8-13
10