Yamaha FJR13AG Service Manual page 761

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
Diagnostic
code No.
09 Fuel system voltage
(battery voltage)
13 Throttle position sensor sig-
nal 2
• Fully closed position
• Fully open position
14 Accelerator position sensor
signal 1
• Fully closed position
• Fully open position
15 Accelerator position sensor
signal 2
• Fully closed position
• Fully open position
16 Front wheel vehicle speed
pulses
17 Bank angle display
(FJR13ESG)
20 Sidestand switch
• Stand retracted
• Stand extended
21 Gear position switch and
clutch switch
• Transmission is in neutral
• Transmission is in gear or
the clutch lever released
• Clutch lever is squeezed
with the transmission in
gear and when the side-
stand is retracted
• Clutch lever is squeezed
with the transmission in
gear and when the side-
stand is extended
Item
Approximately 12.0
9–23
94–108
12–22
97–107
10–24
95–109
Front wheel speed pulse
0–999
0–5°: Upright
Less than approximately 30°:
On the sidestand
ON
OFF
ON
OFF
ON
OFF
9-16
Tool display
Set the start/engine stop
switch to "
pare the actually measured
battery voltage with the tool
display value. (If the actually
measured battery voltage is
low, recharge the battery.)
Check with throttle valves ful-
ly closed.
Check with throttle valves ful-
ly open.
Check with throttle grip fully
closed position.
Check with throttle grip fully
open position.
Check with throttle grip fully
closed position.
Check with throttle grip fully
open position.
Check that the number in-
creases when the front wheel
is rotated. The number is cu-
mulative and does not reset
each time the wheel is
stopped.
Hold the vehicle upright and
place the vehicle on the side-
stand.
Extend and retract the side-
stand (with the transmission
in gear).
Operate the transmission,
clutch lever, and side stand.
(ECU)
Procedure
", and then com-