Yamaha FJR13AG Service Manual page 210

ECA18120
NOTICE
Before tightening the wheel axle bolt, push
down hard on the handlebars several times
and check if the front fork rebounds smooth-
ly.
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Insert the front wheel axle from the right side
and tighten it with the front wheel axle bolt
from the left side to 91 Nm (9.1 m·kgf, 66
ft·lbf).
b. In the order pinch bolt "2" → pinch bolt "1" →
pinch bolt "2", tighten each bolt to 21 Nm (2.1
m·kgf, 15 ft·lbf) without performing temporary
tightening.
c. Check that the right end of the front wheel
axle is flush with the front fork. If necessary,
manually push the front wheel axle or lightly
tap it with a soft hammer until its end is flush
with the front fork. However, if the surface of
the front wheel axle end is not parallel to the
surface of the front fork, align a point on the
outer edge of the axle with the fork, making
sure that the axle does not protrude past the
fork.
d. In the order pinch bolt "4" → pinch bolt "3" →
pinch bolt "4", tighten each bolt to 21 Nm (2.1
m·kgf, 15 ft·lbf) without performing temporary
tightening.
3
4
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
6. Measure:
TIP
Measure the distance "a" only if the wheel bear-
ings, wheel sensor rotor, or both were replaced.
• Distance "a"
(between the wheel sensor rotor "1" and
wheel sensor housing "2")
Out of specification → Reinstall the bearing
or replace the wheel sensor rotor.
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
2 1
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
4-37
Distance "a" (between the wheel
sensor rotor and wheel sensor
housing)
28.82–29.66 mm (1.135–1.168 in)
a
7. Install:
• Front brake calipers
• Front wheel sensor
Front brake caliper bolt
40 Nm (4.0 m·kgf, 29 ft·lbf)
Front wheel sensor bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
TIP
When installing the front wheel sensor, check
the wheel sensor lead for twists and the sensor
electrode for foreign materials.
ECA18130
NOTICE
Make sure there are no foreign materials in
the wheel hub. Foreign materials cause dam-
age to the inner sensor rotor and wheel sen-
sor.
TIP
To route the front wheel sensor lead, refer to
"CABLE ROUTING (FJR13AG)" on page 2-35
and "CABLE ROUTING (FJR13ESG)" on page
2-57.
EWA13500
WARNING
Make sure the brake hose is routed properly.
8. Check:
• Front wheel sensor installation
Check if the wheel sensor housing is installed
properly.
9. Install:
• Front fender
FRONT WHEEL
2
1