Yamaha FJR13AG Service Manual page 349

Timing chain tensioner cap bolt
6 Nm (0.6 m·kgf, 4.3 ft·lbf)
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
7. Turn:
• Crankshaft
(several turns clockwise)
8. Check:
• "T" mark
Make sure the "T" mark "a" on the pickup ro-
tor is aligned with the crankcase mating sur-
face "b".
• Camshaft holes
Make sure the holes "c" in the camshafts are
aligned with the arrow marks "d" on the cam-
shaft caps.
Out of alignment → Adjust.
Refer to the installation steps above.
b
a
9. Measure:
• Valve clearance
Out of specification → Adjust.
Refer to "ADJUSTING THE VALVE CLEAR-
ANCE" on page 3-5.
10.Install:
• Cylinder head cover gasket "3"
• Cylinder head cover
Cylinder head cover bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
New
5-20
TIP
• Apply Three Bond 1514C® "1" onto the mating
surfaces of the cylinder head cover and cylin-
der head cover gasket.
• Apply Yamaha bond No.1215® "2" onto the
mating surfaces of the cylinder head cover
gasket and cylinder head.
• Install a new cylinder head cover gasket "3",
and then cut the portions "a".
• Tighten the cylinder head cover bolts in stages
and in a crisscross pattern.
Yamaha bond No. 1215
90890-85505
(Three bond No.1215®)
3 New
2
11.Install:
• Cylinder head cover plate "1"
TIP
Be sure the "UP" mark "a" is facing up.
CAMSHAFTS
2
a
a
1
1
a