a. High position
b. Standard position
c. Low position
b. Move the shift pedal to the desired position.
c. Install the shift pedal bolt, and then tighten it
to specification.
Shift pedal bolt
7 Nm (0.7 m·kg, 5.1 ft·lb)
LOCTITE
L
LLL
L LLL
L
L LLL
L
EAS21460
CHECKING THE FINAL GEAR OIL LEVEL
1. Stand the vehicle on a level surface.
NOTE:
• Place the vehicle on the centerstand.
• Make sure the vehicle is upright.
2. Remove:
• Final gear oil filler bolt "1"
3. Check:
• Final gear oil level
The final gear oil level should be to the bot-
tom brim "2" of the filler hole.
Below the bottom brim → Add the recom-
mended final gear oil to the proper level.
Type
Shaft drive gear oil (Part No.:
9079E-SH001–00)
®
L LLL
L
L LLL
L
L LLL
L
4. Install:
• Final gear oil filler bolt
EAS21470
CHANGING THE FINAL GEAR OIL
1. Place a container under the final gear case.
2. Remove:
• Final gear oil filler bolt "1"
• Final gear oil drain bolt "2"
Completely drain the final gear case of its oil.
LLL
3. Check:
• Final gear oil drain bolt gasket
Damage → Replace.
4. Install:
• Final gear oil drain bolt
(along with the gasket
5. Fill:
• Final gear case
(with the specified amount of the recom-
mended final gear oil)
Refer to "CHECKING THE FINAL GEAR OIL
LEVEL" on page 3-33.
EAS21510
CHECKING AND ADJUSTING THE
STEERING HEAD
1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
3-33
Final gear oil filler bolt
23 Nm (2.3 m·kg, 17 ft·lb)
New
Final gear oil drain bolt
23 Nm (2.3 m·kg, 17 ft·lb)
Quantity
0.20 L (0.21 US qt) (0.18 Imp.qt)
CHASSIS
)