Yamaha FJR13AG Service Manual page 99

1. Wire harness
2. Tail/brake light assembly coupler
3. Tail/brake light assembly
4. Rear turn signal light lead
5. License plate light lead
6. Seat lock cable
7. Option parts (air bag coupler)
8. Rear wheel sensor lead
9. Rear brake light switch lead
10. Hydraulic unit assembly
11. Brake light relay
12. Brake switch relay
13. ABS ECU coupler
14. Tail/brake light
15. Rear turn signal light
A. Route the wire harness so that the joint couplers
are positioned on top of the harness.
B. Pass the license plate light lead through the hole in
the rear fender.
C. Route the wire harness to the inside of the seat
lock cable.
D. Securely connect the ABS ECU coupler.
E. Secure the plastic band by inserting the projection
on the band into the hole in the rear fender, and
then fasten the wire harness at the positioning tape
with the band.
F. Insert the projection on the wire harness holder
into the hole in the rear fender.
G. Route the tail/brake light assembly lead as shown
in the illustration.
H. Route the tail/brake light assembly lead between
the tail/brake light assembly and its bracket.
CABLE ROUTING (FJR13AG)
2-46