Yamaha FJR13AG Service Manual page 716

ELECTRONICALLY ADJUSTABLE SUSPENSION SYSTEM
Fault code No.
Item
2 Malfunction in SCU.
Fault code No. C1007
TIP
• After the malfunction is repaired and the preload is adjusted, fault code No. C1007 may not disappear
if the main switch is turned to "ON" within approximately 6 minutes after the rear shock absorber as-
sembly DC motor stops. If this occurs, turn the main switch to "OFF", wait approximately 6 minutes,
and then turn the main switch to "ON".
• If a fault code number other than "C1007" is indicated, take the actions specified for that fault code
number first.
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Tool display
Procedure
Probable cause of malfunc-
Item
tion and check
1 Malfunction in SCU.
Fault code No. P0560
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Tool display
Procedure
Probable cause of malfunc-
Item
tion and check
C1005
Defective preload adjusting motor (DC motor).
Replace the SCU.
C1007
SCU (suspension control unit): open or short circuit detected.
Able to start engine
Able to drive vehicle
84
The "check" indicator on the Yamaha diagnostic tool screen comes on
when the preload home position adjustment starts.
When completed successfully
The "check" indicator on the Yamaha diagnostic tool screen goes off.
When not completed successfully
The "check" indicator on the Yamaha diagnostic tool screen flashes. Re-
move the rear shock absorber assembly DC motor and adjust it by hand.
After adjusting the DC motor, perform the procedure for diagnostic code
No. 84 again. If the "check" indicator on the Yamaha diagnostic tool
screen flashes again, replace the rear shock absorber assembly.
—
Maintenance job
Replace the SCU.
P0560
Charging voltage is abnormal.
Able to start engine
Able to drive vehicle
09
0-18.7 V
Compare the actually measured battery voltage with the tool display val-
ue. (If the actually measured battery voltage is low, recharge the battery.)
Maintenance job
8-239
(FJR13ESG)
Execute the diagnostic mode
(code No. 84). Service is fin-
ished.
Confirmation of service com-
pletion
Execute the diagnostic mode
(code No. 84). Service is fin-
ished.
Confirmation of service com-
pletion