Yamaha FJR13AG Service Manual page 612

Fault code No. U0155 or "Err"
TIP
"Err" is displayed on the clock display of the multi-function meter, but the engine trouble warning light
does not come on.
Fault code No.
Item
Probable cause of malfunc-
Item
tion and check
1 Connection of meter assembly
coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
2 Connection of ECU coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
3 Wire harness continuity.
4 Defective meter assembly.
5 Malfunction in ECU.
6 Delete the fault code and check
that the engine trouble warning
light goes off.
U0155 or "Err"
Multi-function meter: signals cannot be transmitted between the
ECU and the multi-function meter.
Maintenance job
Improperly connected → Con-
nect the coupler securely or re-
place the wire harness.
Improperly connected → Con-
nect the coupler securely or re-
place the wire harness.
Open or short circuit → Replace
the wire harness.
Between meter assembly cou-
pler and ECU coupler.
blue/black–blue/black
blue/red–blue/red
Replace the meter assembly.
Replace the ECU.
Refer to "REPLACING THE
ECU (engine control unit)" on
page 8-250.
Confirm that the fault code has
a condition of "Recovered" us-
ing the Yamaha diagnostic tool,
and then delete the fault code.
8-135
FUEL INJECTION SYSTEM
Confirmation of service com-
pletion
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is "Recovered" → Go
to item 6 and finish the service.
Condition is "Detected" → Go to
item 2.
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is "Recovered" → Go
to item 6 and finish the service.
Condition is "Detected" → Go to
item 3.
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is "Recovered" → Go
to item 6 and finish the service.
Condition is "Detected" → Go to
item 4.
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is "Recovered" → Go
to item 6 and finish the service.
Condition is "Detected" → Go to
item 5.
Service is finished.