Yamaha FJR13AG Service Manual page 125

1. SCU (Suspension Control Unit)
2. Storage compartment
3. Yamaha diagnostic tool lead
4. Yamaha diagnostic tool coupler
5. IMU sub-wire harness
6. IMU (Inertial Measurement Unit)
7. License plate light connector
8. Tail/brake light assembly lead
9. Seat lock cable
10. SCU lead
A. Route the Yamaha diagnostic tool lead to the rear
of the positioning ribs and under the band that is
used to secure the SCU (suspension control unit).
B. Install the protective cap onto the Yamaha
diagnostic tool coupler, and then install the coupler
onto the projection on the storage compartment.
C. Fasten the tail/brake light assembly lead and IMU
sub-wire harness with the holder.
D. Route the tail/brake light assembly lead and IMU
sub-wire harness between the ribs on the rear
fender.
E. Route the Yamaha diagnostic tool lead over the
SCU lead.
CABLE ROUTING (FJR13ESG)
2-72