Table of Contents
Advertisement
Mounting Using a Center Securing Screw
NOTE: Applies to European Installations.
1. Detach case front by removing the two
bottom screws. Gently pull up using a
screwdriver if necessary and pry apart.
Lift off cover.
2. Mount Tuxedo in its final location, (see
"Standard Mounting" or "Mounting
without the mounting plate") install
center securing screw (supplied) and
tighten to mounting surface.
3. Replace the case front and secure
using the two bottom screws.
The European mounting procedure has not been evaluated for agency compliant application.
Wiring
Connect the Tuxedo in parallel with keypads and other peripheral devices using the keypad data (ECP) bus, by adhering to
the standards below.
ECP Wire Limitations
Connect keypads and other addressable devices as shown in "Supplementary Power Supply Connections" section. The
table below establishes ECP device wire gauge:
Wire
Length
Gauge
#22 gauge
150 feet
240 feet
#20 gauge
#18 gauge
350 feet
#16 gauge
550 feet
• If more than one Tuxedo is wired to one run, then the maximum lengths must be divided by the number of
keypads on the run. (e.g., the maximum length is 75 feet if two Tuxedos are wired on a #22-gauge run).
• If Tuxedo is used as the primary system keypad, maximum wire run lengths must not exceed the lengths
listed in the table above.
TUXEDO TOUCH WI-FI INSTALLATION & SETUP GUIDE
CASE
BACK
DETACH CASE FRONT
BY REMOVING SCREWS (2)
Tuxedo draws up to 340mA for 9.6VDC, 260mA for 12VDC, 250mA
for 13.8VDC. If you power Tuxedo from your panel's Aux Power
output, check your panel's Installation and Setup Guide and verify
that this device and others do not exceed your panel's Aux Power
output capability. If it does, a supplementary power supply is
needed.
4
INSTALL CENTER
CASE
SECURING SCREW
FRONT
AND LIFT UP
6280-015-V1
Advertisement
Table of Contents
