Table of Contents
Advertisement
TUXEDO TOUCH WI-FI INSTALLATION & SETUP GUIDE
Others
Feature
Reset to Default
Restart Camera
Camera functionality is supplementary only and has not been evaluated for agency compliant
installations.
Removing Cameras
1.
To delete a camera, highlight the camera name and press DELETE. A confirmation window displays
want to delete "the selected" camera? Yes or No. If Yes is selected, a message Select Yes to permanently
remove the camera name device from the list. Note: select delete all then select discover to rediscover all
devices" appears.
2. To delete all cameras, press DELETE ALL. A confirmation window displays "Do you want to delete
all cameras?" Yes or No.
NOTE: If any single camera is removed, all cameras must be removed before that camera can be re-added to the
camera list. This is done by performing a Camera Discovery.
Viewing Cameras
Cameras can be viewed locally from the Tuxedo keypad.
NOTE: To setup and view cameras for use with Wi-Fi enabled devices and Total Connect, refer to the Remote Access
section later in this document.
Camera Icons
Camera Settings Play
To view cameras locally, do the following:
1.
Press Multi-Media
2.
Highlight the View Cameras button; images from installed cameras appear.
3.
Use the Quad View button to view up to four cameras on the same screen.
4.
Select a quadrant area on the screen and then select the camera that you want to appear in that quadrant.
NOTES:
For pan/tilt style cameras, use Pan/Tilt to change the angle of the selected camera.
•
Camera Play/Pause functionality is not supported from the web access.
•
If the resolution is greater than 320X240, the keypad will crop it to 320X240.
•
Video Recording & Event Viewing
The camera Recording feature allows you to create a scene that records two minutes of video events onto the SD card.
The first 15 seconds records the pre-event and the remaining time records the post-event. Up to four simultaneous video
events can be recorded and the
card is required to store the recordings.
For proper recording, use the following camera settings for the resolution and frame rate:
640X480, less than 5 frames per second
•
320X240, less than 8 frames per second
•
Critical Events
This option is enabled in the Creating Scenes section. When this option is enabled, a maximum of two events are
recorded even when the SD card is not available. If more than two critical events occur, then the older one is replaced by
the latest event.
Video recording is for lifestyle and awareness purpose only. Using this feature for life safety, person
and property protection should be prohibited. It is not certified for any agency compliant installations,
because it may fail at any time without any notice.
To access the recording feature:
Description and Options
Factory defaults the Camera
A pop window displays: "Do you want to reset the Camera" select Yes or No
Provides a reboot of the camera
Auto Pan
Quad View
> Camera View/Record
first four supported cameras will be associated (automatically) to the
Full View Pan/Tilt Connect
.
31
Reset
Record
Recording Settings
recording. An SD
"
Do you
Advertisement
Table of Contents
