Table of Contents
Advertisement
TUXEDO TOUCH WI-FI INSTALLATION & SETUP GUIDE
NOTE: The message "Please remove all Z-wave devices from network first" appears if Z-Wave devices are
enrolled. If no Z-Wave devices exist, a confirmation will display "Change to Secondary Controller? Note:
Total Connect feature will be unavailable in secondary controller mode." Select Yes to change this keypad to a
Secondary Controller.
3. At Tuxedo #1, Press Add Device
4. At Tuxedo #2: Press Add Device, the keypad displays "Secondary Controller Inclusion Devices Upload in
process." When device information from the Primary Tuxedo is downloaded to the Secondary Tuxedo:
• The Secondary Tuxedo displays "Device Upload in Process." Once devices have been uploaded,
"Devices Uploaded Successfully" is displayed.
• The Primary Tuxedo displays "Device Added Successfully."
Notes:
• If the device status is failed, remove and enroll Tuxedo as the secondary controller again and then reboot the
system; verify that the two controllers are less than 40 feet apart.
• Device names will NOT be synchronized upon initial Tuxedo Z-Wave device transfer.
• Secondary keypad will not receive device low battery status automatically, must perform a manual refresh.
Synchronizing Device Names
Synchronizing the names of the Z-Wave devices requires a connection the same network (Wi-Fi or LAN).
Note: User always has to perform the sync from the secondary Tuxedo.
1. At Tuxedo #2 (Secondary Controller): Press the Automation
2. Press Sync Device Names a message displays "This will synchronize device name(s) with the primary controller.
This will overwrite the device names. Do you want to continue Z-Wave device name(s) sync operation with the
primary Tuxedo?" Yes or No.
3. A message will be displayed at the top of the screen stating "Z-Wave name synchronization in process. Please
wait..."
4. When completed the message "Z-Wave name synchronization completed" appears and the names are synchronized
with the primary Tuxedo.
Updating Tuxedo with New or Removed devices
When devices are added or removed from the Z-Wave network, the device information needs to be updated in the
Tuxedo. perform this update, you must remove the secondary controller and re-enroll.
1.
Press Remove Device on the Primary Tuxedo > Remove Device on the Secondary Tuxedo. Both Tuxedos
display, "Device Removed" and the Secondary reverts to the Primary Tuxedo.
2.
Convert the second Tuxedo back to a primary following the steps above.
3.
Press Add Device on Primary Tuxedo controller > Add Device on Secondary Tuxedo controller. The controller
scans for devices in the primary controller and the message is displayed "Devices added Successfully" followed
by "Devices Uploaded Successfully."
NOTE: The secondary Tuxedo must be within 10' of the primary controller for best results.
Removing Secondary Tuxedo's
To remove the Secondary Tuxedo (Controller) press Remove Device on the Primary Tuxedo > Remove Device on the
Secondary Tuxedo. Both Tuxedos display, "Device Removed" and the Secondary reverts to the Primary Tuxedo.
Manual Z-Wave Device Control
To access the list of Z-Wave devices and view the status of the enrolled devices, press Automation. Use the
OFF/ON/Slide Bar buttons to control the Z-Wave modules. The Z-Wave devices are group in the following order:
Thermostats, Door Locks, Garage Doors, Multi-Level Switches, Binary Switches, Water Valves and Shades.
.
> Z-Wave Setup
47
.
Advertisement
Table of Contents
