Table of Contents
Advertisement
TUXEDO TOUCH WI-FI INSTALLATION & SETUP GUIDE
Add/Edit Options
If the camera information is not discovered automatically, press Add to enter information on the "Add New Camera"
screen.
Name
Camera Name
Camera IP Address
MJPEG Streaming URL
RTSP
Resolution
Camera Model:
RTSP Streaming URL
Mobile Streaming URL
HTTP Port
Frame Rate
User Name/Password
NOTE: Every camera manufacturer makes their cameras slightly different, so Resideo does not guarantee that
Tuxedo will work with every camera that supports the above network and codec features.
If using Total Connect, press Total Connect
default for Total Connect compatibility. A pop-up window displays: "For remote camera viewing service, please contact
your alarm company and ask for Total Connect
Press continue to prepare the camera for Total Connect service." Press CONTINUE or CANCEL. Pressing Continue
provides a confirmation window, which displays: "Do you want to reset the Camera?" Yes or No. See Remote Access
section, later in this document. Press Save when done. Use Refresh
Setting the Camera's Wi-Fi
If the camera is configured as a LAN connection, and the final installation location is only accessible wirelessly, the
option will allow you to assign the camera to the Wi-Fi network. After all cameras have been added,
Camera WIFI
Description
NOTE: Must be alphanumeric only, no special characters (including
space) are compatible.
Default is the Camera Model (abbreviated) X, where X= The
Mac
NOTE: Maximum # of cameras supported.
This is the address of the camera, which is assigned by the
router
Fixed
(Real Time Streaming Protocol) Port #. Select ports (554, (1024-
65534))
(Options are 160x120, 320x240, 640x480)
Select from 160 x 120, 320 x 240 or 640 x 480. For best
performance set video resolution to 320 x 240, 8 frames per sec.
NOTE:
• Model iPCAM-WL resolution is fixed at 320 x 240 or user can
change to 640x480.
• When setting the resolution to 640 x 480, the recommended
frame rate is eight frames per sec.
When setting the resolution to 320 x 240, the recommended
frame rate is no more than 15 frames pre sec.]
Select iPCAM-WI, iPCAM-WI2, iPCAM-WI2B (black), iPCAM-
WO or iPCAM-PT, WVC210, iPCAM-ACU, iPCAM-WL, ONVIF,
Trendnet, and others.
NOTE: Only the Resideo/AlarmNet IP cameras will work with
Total Connect Remote Services. Refer to
www.tuxedotouchtoolkit.com for the "Camera Compatibility"
documentation.
Real Time Streaming Protocol, if using a Non-AlarmNet IP
camera, this information will be retrieved from the camera or
the cameras interface page
Fixed
Default value = 80. To change enter valid port number (80
(1024-65534)).
NOTE: Do not use ports 6665-6669 for camera HTTP
configuration. These ports block MPEG streaming and PT
commands of Safari based PC and mobile devices
Options are 1, 2, 3, 4, 5, 6, 8, 10, 15, 20, 25, or 30.
Administrative password to access the camera's setup or
viewing page.
to reset the camera for remote viewing. This programs the camera to
TM
service and provide the camera's MAC ID XX:XX:XX:XX:XX:XX.
29
www.resideo.com
or
to update the screen, if necessary.
Advertisement
Table of Contents
