Camera Options And Setup; First Time Setup - Honeywell Home Tuxedo Touch TUXWIFIS Installation And Setup Manual

Camera Options and Setup

The access the camera setupage press Multimedia
NOTES:
• Keypad must be connected to same LAN or Wi-Fi network as the cameras, before they can connect.
• View the "IP Camera Setup" training video for helpful information to aid in the setup.
• Supports up to 32 cameras with up to four cameras viewable at one time.
NOTES:
QuickTime® media player must be installed on your PC.
•
Camera viewing is compatible with IE8 (and above) and Safari 5.0 (and above); and not compatible with Opera
•
web browsers or Chrome version 42 or above.
Some older versions of these cameras may need a firmware upgrade; see separate instructions.
•
The cameras will appear in a Quad View mode, however, you can select icon in bottom right corner for single view.
•
Use the web browser to view cameras for non-security purposes only. Camera streams viewed from
the web browser can stop without indication due to network connection issues.
Icon

First Time Setup

Scan and configure the cameras prior to mounting; follow the steps below:
1. Connect an Ethernet cable to the back of your camera (LAN); connect the opposite end to the Ethernet Port on
your router (or Resideo-WAP, as long as it is connected to the router). Apply power to the Camera. Wait 60
seconds for initial power-up of camera.
NOTE: A LAN connection is initially required, once the camera is configured with the Camera WIFI
will change if from a LAN to Wi-Fi connection.
2. Press Discover
this step until all cameras are discovered.
Notes:
• All devices enabled for UPNP (Universal Plug and Play) will be discovered.
• Delete the unwanted devices.
The Tuxedo will do a 24-hour refresh (to make sure the IP address has not changed.) The deleted devices will not
populate again during the 24-hour refresh.
• If new cameras will not discover, you can manually enter or wait for the 24-hour refresh.
3. To edit information, highlight the camera name and press Edit
information (see Add/Edit Options below), and then press Save
To retrieve camera settings and connect to the camera, press Connect
Name Description
Camera Discovery Discovers all cameras with UPNP Enable
Add Camera Manually add a camera
Edit Camera Edit existing camera
Delete Delete a selected camera
Delete All
Delete all camera's
Camera Settings Review the camera's current setting
Camera Wi-Fi Changes the selected camera from LAN to Wi-Fi
Recording Settings Adjust the recording settings for each camera
to locate cameras. The screen displays: "Discovering Cameras Please Wait..." Repeat
TUXEDO TOUCH WI-FI INSTALLATION & SETUP GUIDE
> Camera View/Record
. Highlight each field and enter the required
.
.
28
> Camera .
Setup
option it