Keypad Reset
Press the Keypad Reset
"Confirmation Are you sure you want to reset?"
Select Yes or No.
NOTE: This is not a factory default, but simply an
option to reboot the keypad.
End User License Agreement (EULA)
To review the EULA, you can choose "End-User License
Agreement."
Factory Default
To return the keypad to factory defaults, press the
following Factory Default. The message displays, "Are
you sure you want to restore the Tuxedo device to
factory defaults? All settings will be erased and the
keypad will reset!" If Yes is selected, Tuxedo reboots
and reverts to factory default settings.
This does not default any installed Z-Wave devices, but does remove their names and any scenes,
groups and rooms that may have been created. Write down the names of each device and the
configuration of each scene and detailed information about the groups and rooms.
Output Setup
Tuxedo can activate/deactivate up to 18 pre-defined control panel output functions (if programmed in the control panel).
The Output Setup screen displays Output selections. Control these output functions by enabling/disabling as follows:
Press Output Setup
confirmation window displays Information Settings saved Press OK to save the setting.
If the Back
is pressed, a confirmation window displays "Output Settings changed. Do you want to save new
settings?" Select Yes or No.
NOTE: This is a local setting for the graphic keypad. If user has the maximum number of keypads on the system, and
wants to disable the same output for all, each Tuxedo needs to be set individually.
Night Setup Function
The NIGHT function can be set to arm the system in one of five arming modes:
• Away - Arms all zones with entry delay.
• Stay - Arms perimeter zones with entry delay.
• Instant - Arms perimeter zones without entry delay.
• Night (Residential Panels Only) – Arms all perimeter zones. All interior zones are also bypassed, except for those
zones programmed in zone list five.
• Maximum - Arms all zones without entry delay. Not to be used for ANSI/SIA CP-01 installations.
To set the NIGHT function, do the following:
Select the arming mode to be activated when NIGHT
setting. Back
cancels your selection.
; the message is displayed
> select the outputs to display or not display on the Output screen > Apply
TUXEDO TOUCH WI-FI INSTALLATION & SETUP GUIDE
is selected on the "Arming" screen. Apply
26
. A
accepts the