Table of Contents
Advertisement
Commercial Control Panels (Non-Turbo)
Commercial Control Panels consist of the VISTA-128BP, VISTA-250BP and VISTA-128FBP, VISTA-250FBP and 32FBP
or equivalent.
• Addresses 1-2, and 3-30 may be used for older controls under revision 10, which supports three AUI's. These
addresses in the control panel are not defaulted for AUI type devices. To enable the addresses you are using for
keypads, use an alpha-keypad and follow the procedures for "Device Programming" in your control panel
"Programming Guide." NOTE: It is recommended that address 1 is programmed for AUI and one of the
keypad is assigned to it.
• If multiple keypads are being used, they must be set to addresses 1, 2, and X (where X equals any address from
three through 30). Only one AUI type device may be assigned to an address from three through 30 on
commercial control panels under revision 10.
Vista-Turbo Commercial Control Panels
The commercial family consist of the VISTA-128BPT, VISAT-250BPT and VISTA-128FBT, VISTA-250FBPT, 32FBPT or
equivalent.
• Any address 1-30 can be used for an AUI keypad, the Vista-Turbo panels can support up to 6 AUI keypads
• If using Total Connect the RIS option must be enabled in the panel. This is enabled by setting the device type
to 12 for the address. Refer to the AlarmNet Communicator to determine which address to use (See "Important
Notes" below.)
Important Notes:
• The RIS option must be enabled in the AlarmNet Communicator. Failure to do so will prevent control of the
automation devices enrolled in the keypad from Total Connect.
• The Keypad should not be assigned as a Master Console. If the keypad is assigned as a Master Console
(partition 9), partitions must be controlled from the Partition screen or using the Console Emulation Mode.
Quick Programming (VIP Mode)
Tuxedo supports Quick Programming VIP (Vista
that supports this feature. Check the control panels manual to check if it supports this function and for further
instructions.
See the "Quick Programming" section for more information.
Data Entry Keyboard
Throughout this document, the user is required to enter information on the Tuxedo Keypad (i.e., password, device
names etc.) Use the Data Entry Keyboard to enter all required information.
• Press the Up Arrow to switch to upper case characters.
• Press the Space key to add a space between characters.
• Press the X key to delete/backspace.
• Press the ABC/123 key to switch between numerals and symbols/characters.
• Press GO to return to the previous screen.
TUXEDO TOUCH WI-FI INSTALLATION & SETUP GUIDE
Intelligent Programming) mode when used with a control panel
®
6
Advertisement
Table of Contents
