Table of Contents
Advertisement
TUXEDO TOUCH WI-FI INSTALLATION & SETUP GUIDE
Viewing and Controlling Total Connect Scenes from Tuxedo
Use Scenes to display and control scenes that have been created in Total Connect.
1.
From the "Home" screen, press Automation
scenes created in Total Connect.
2.
To control a Remote scene, select the desired scene, and then click the appropriate action (ex. Run).
Creating Scenes in Total Connect
The following table summarizes the relationships between Total Connect scenes and Tuxedo scenes:
Controlling
Device
Total Connect
Tuxedo
Note: For troubleshooting purposes, Total Connect server information (including IP addresses) can be viewed on the
Total Connect Server Setup screen by pressing the TC SERVER INFO button.
Use the Automation section of the dashboard in Total Connect to create up to 20 scenes. Refer to the Total Connect
Online Help Guide for further details and device limitations for creating an automation scene.
Access the Total Connect account and navigate to the Automation module. Press Create New > Enter a name
1.
for the scene > select an icon > and then press on the check boxes for the various device actions desired for that
scene. Set the thermostat, if used, to the desired mode and/or temperature for that scene. Press Save when
done.
Scene triggers and actions created in Total Connect can be edited only from Total Connect.
Scene conditions cannot be programmed through Total Connect.
2.
After scenes have been created, follow the Total Connect prompts to synchronize the data with the Tuxedo.
Synchronizing is required before scenes created in Total Connect will display in Tuxedo.
Total Connect Server Screen for Troubleshooting
The "TC Server Info" screen displays the current server information and Z-Wave device status. This information is
typically used for IP connection troubleshooting purposes in collaboration with a service technician.
Diagnostic
Connect
Cancel
Total Connect
Device Select
To access Total Connect Server Information and Z-Wave Status from the Tuxedo keypad, do the following:
1.
From the "Home" Screen, press Setup
2.
Press the TC SERVER INFO button. The "Total Connect Server Setup" screen is displayed with the current
Server information and Z-Wave Status (enabled/disabled).
NOTE: These fields are for reference only and cannot be edited.
Press Connect
3.
Scenes created in Total Connect
View
Edit Scenes
Yes
Yes
Yes
No
Clicking Diagnostic Connect in the bottom left corner will test the communication
status to the AlarmNet server. If the test fails, check your network connection.
This cancels the Diagnostic Test above.
Verification of the Z-Wave status: If enabled it will communicate Z-Wave status to
Total Connect 2.0.
Pressing the "TC" icon will populate a list of all your Z-Wave devices with an enable
or disable option. This will allow or prevent those chosen devices from appearing on
the Total Connect account.
to test the connection to the AlarmNet servers.
> Scene Setup
Scenes created in Tuxedo
View
No
Yes
> System
> CS Setup
49
> Remote. The screen displays a list of
Edit Scenes
No
Yes
> enter the installer code (if required).
Advertisement
Table of Contents
