Table of Contents
Advertisement
1. Press Camera View/Record
resolution, fixed quality and frame rate, see the Camera Add/Edit section.
NOTES:
• The recommended frame rate is eight frames per sec, when setting the resolution to 640 x 480.
• The recommended frame rate is no more than 15 frames per second, when setting the resolution to 320 x 240.
• To get a 2-minute recording the Frames Per Second should be 5 frames or less
2. Press Save when done. This will return you to the Camera Setup Management screen.
3. Press Recording Settings
NOTE: This is where the camera is assigned when Creating a Scene to activate a camera on an event.
4. Press Save when done.
Manual Video Recording
The camera-recording feature can also be used manually to record events to an SD Card (supplied).
To access the manual video recording feature, press Camera Record
Select the desired camera for recording and then press Record
Press Record
again to stop the recording.
NOTE: The maximum recording duration is two minutes.
Using Third Party Cameras
The Tuxedo keypad can support cameras by multiple manufacturers. For a complete list visit www.resideo.com or
www.tuxedotouchtoolkit.com and refer to the IP Camera Compatibility List for supported cameras.
General Notes:
• A maximum of four cameras can be enabled for remote viewing with the same account activation. If more than four
cameras are needed for remote viewing, user can use manual port forwarding in router. For manual port forwarding,
the recommended internal port configuration is 80 for HTTP and 443 for HTTPS.
• Cameras can be enabled or disabled from the Tuxedo Camera Setup screen for remote viewing.
• Using the Multimedia camera view, and other web pages, there are the chances that the session could timeout and the
connection with Tuxedo web server will be terminated. In this case, the top bar status updates and all other status
updates from Tuxedo will fail. It is advised to refresh the page and continue using the web application.
Event Viewing
To view a cameras' recorded event:
1. Press Multimedia
2. Press Event View Setup
All to view all camera events or select Filter By Critical to view (if enabled) a maximum of two events that have been
stored, when the SD card is not available.
3. Press Save when done.
4. Highlight the event from the list to view, and press Play
5. Use Delete
to remove the event video.
> Camera Setup
and select a camera to assign to "Recording Cam 1-4" from the drop down list.
> Event View
; the list of events appears on the screen.
and select the Filter by Camera button to view a specific cameras' event, select Show
TUXEDO TOUCH WI-FI INSTALLATION & SETUP GUIDE
> Camera Settings
on the camera view screen.
to begin recording.
.
32
. To change the settings for
Advertisement
Table of Contents
