Table of Contents
Advertisement
Group Setup
A group is a defined collection of the same type of Z-Wave devices (such as only light modules, or only door locks, etc.)
that can be used in scenes. When used in a scene and the scene activates, all devices assigned to that group activate.
Up to 20 groups can be created with up to five of the same type devices in each group, such as five door locks, etc. Follow
the procedure below to create a Group.
1.
Press Group Setup
2.
Highlight Group Name > Group Name.
3.
Select the Group Type (Binary Light, Door Lock, Thermostat, Multilevel Switch, Shades, Water Valve, Garage
Door Controllers, and Other) from the drop-down list.
4.
Highlight the device(s) from the drop-down list that you want to add to this Group and press Save. A
confirmation message is displayed: Z-Wave device group settings saved.
NOTES:
Select Edit to make changes to existing Groups; use Delete to delete a Group.
•
The "Water Valve Group" is excluded from the "All Switches On/Off" command on the "Device Control" page.
•
Room Setup
A room is a defined collection of different types of Z-Wave devices (such as light modules, door locks, thermostats, etc.)
which can be used to organize the Z-Wave devices. Up to 50 rooms can be created with no limitation to the number of
devices in each room.
Example 1: Screen Interface
Follow the procedure below to create a Room.
1.
Press Room Setup > Add.
2.
Enter a room name > GO.
3.
Check the box next to the device(s) that will be assigned to this Room > Save.
4.
Select Edit to make changes to existing Rooms; use Delete to delete a Room.
5.
If settings were changed, a pop-up confirmation window displays Settings Saved.
Secondary Tuxedo Controller
After all Z-Wave devices have been added into the Primary Tuxedo (#1), the device information can be downloaded to a
Secondary Tuxedo (#2). Up to 231 secondary plus 1 primary controller, for a total of 232. Keep Tuxedos within 40 feet of
each other (if it does not work, move the keypad closer to the primary), apply power to Tuxedo #2 and do the following:
1. At Tuxedo #1 (Primary Controller): Press Automation > Z-Wave Setup
screen is displayed.
NOTE: If used for Remote Services, Tuxedo should not be configured as a secondary controller. See the Remote
Services section later in this document.
2. At Tuxedo #2 (Secondary Controller): Press the Z-Wave Primary
screen). The icon
.
> Add
changes to an
icon, representing the controller is now in secondary mode.
TUXEDO TOUCH WI-FI INSTALLATION & SETUP GUIDE
Example 2: Assigning Devices
Room
Kitchen
Name
Kitchen Over
Device 1
Head Light
Kitchen Cabinet
Device 2
Lights
Kitchen Fan
Device 3
Kitchen
Device 4
icon (located in the lower right side of the
46
Bedroom
Living
Room
Bed.
L.R. Lamp
Lamp
Bed. Fan
L.R. Fan
Bed
L.R. Outlet
Overhead
Light
; the "Z-Wave Device Management"
Advertisement
Table of Contents
