Table of Contents
Advertisement
TUXEDO TOUCH WI-FI INSTALLATION & SETUP GUIDE
Temperature Unit
The temperature units for the weather display on Tuxedo's home screen can be switched between Fahrenheit and
Celsius. Setup > Disp & Audio Setup and enter an authorized code. Select the temperature scale, Celsius or
Fahrenheit.
Clean Screen
With the exception of normal cleaning, the keypad is maintenance free.
Press Setup > Disp & Audio Setup > CLEAN SCREEN
disabled so that you may wipe the screen clean. Please use a damp, soft cloth. DO NOT use any liquids, sprays, or
ammonia-based cleansers. Press CONTINUE to disable touchscreen."
*Panics cannot be initiated during this process*
Press Continue or Cancel to exit or press Save.
NOTE: When Continue is pressed the message "Touch Screen Disabled for 30 Seconds" is displayed. During these 30
seconds, the touch screen should be wiped clean of fingerprints using a mild soap solution and a soft cloth. When
the counter reaches zero, the window automatically closes and the touch screen is active.
IMPORTANT: Do not use an abrasive cleaning agent or abrasive cloth when cleaning Tuxedo or damage to the touch-
screen may occur.
The Emergency screen cannot be accessed while running in the clean screen mode.
IP (Setup)
This section allows you do an initial connection to the Wi-Fi network, or if network change has occurred (i.e. SSID
change, Security Mode, or Passphrase/Shared Key). Setting up a LAN (non-Wi-Fi) connection in DHCP mode will
automatically populate the required network information (IP Address, Subnet Mask, Default Gateway and DNS Server).
NOTE: These fields are not editable. To change the network type to static press the Internet Connection Type from
Dynamic IP to Static IP. Once, this is done the fields are now editable.
Wi-Fi Setup
DHCP Setup
By default, the keypad is configured for DHCP. Once accessing IP, a list of available network will display. Choose the
desired network and enter the following information:
Required Field
SSID
Security Mode
Passphrase/Shared Key
Manual Network Setup
The option to add a custom network is available by selecting Add Network. Connection to this mode requires the
information in the "Required Field" column in the table above. Press Save when completed.
Static Network
The option for a Static Network is only available once you have connected using DHCP, when using a Wi-Fi connection.
After connecting to a Wi-Fi network, select the connected network from the list. The next screen reveals the network
details. Press the "Internet Connection Type" option to allow the IP Address, Subnet Mask, Default Gateway and DNS
Server fields editable.
Port Settings
The Port number (PORT #) listed on the bottom right corner of the screen is required when port forwarding is being
configured. To change the default port number (6280) settings, perform the following steps:
1.
Press the numerical value next to Port # and enter a secondary port number (between 5000 – 65534).
2.
A pop-up window displays the message: "Port number changed. Keypad is going to reset."
3.
At your PC, Smart Phone or Tablet browser, start your browser and enter your IP Address. Refer to the
Remote Access section for further details.
. A pop-up window displays "Touch Screen has been
Description
Network Name
The keypad will automatically detect the security mode of the router
Password to access the network
15
Advertisement
Table of Contents
