Table of Contents
Advertisement
TUXEDO TOUCH WI-FI INSTALLATION & SETUP GUIDE
Detailed Scene Configuration
Scenes must have at least one trigger, 1 action (up to 5) and the event to trigger. The Condition section is optional.
Set the TIME: Press Trigger/Condition > Add > TIME > Set the occurrence.
Time
If ONCE, Enter Date; if REPEATED > choose days of the week; if BY CLOCK > press on the
Hour/Minutes displayed and enter the Start and End Time > press on AM/PM; if SUNRISE or SUNSET >
BY CLOCK until the desired setting is displayed.
Check the Critical Event check box to record and store a maximum of two events even when the SD
card is not available. If more than two critical events occur, then the older one is replaced by the
latest event.
NOTES:
• The Sunrise/Sunset feature is dependent on the "Region" selected in the "Weather Forecast"
section and requires internet access for accuracy.
• BY CLOCK allows you to activate the scene for a specified period.
Set the Security Mode: Press Trigger/Condition/Action > Add > SECURITY > DISARM, AWAY, STAY,
Security
NIGHT, AWAY SECURED or ALARM > User Code, if required.
NOTES:
• AWAY triggers upon arming away.
• AWAY SECURED triggers when exit delay has expired.
Set the Thermostat: Press Trigger/Condition/Action > Add. Press THERMOSTAT and select a
Thermostat
Thermostat device from the drop-down menu or press Select Thermostat Group to activate more
than one device. See the Group Setup section. Use ABOVE or BELOW to increase/decrease the
temperature or press the Temperature Value box and enter two digits for the desired temperature.
NOTES:
• Test thermostats first to ensure proper function in the scene.
• Some thermostats do not update temperature status automatically (i.e., Wayne Dalton).
Set Lights (on/off): Press Action box > Add > LIGHT > Select Light Device from the drop-down
Light
menu or press Select Lights Group (to activate more than one device) > set the action to ON, OFF,
Dim level for multi-level switches; or select ON FOR TIME and press Hour/Minutes > amount time.
NOTE: ON FOR TIME allows you to activate the scene for a specified period.
Set the Door Locks: In the Trigger box, press Add > DOOR > Door Device from the drop-down
Door
menu. Press LOCKED, UNLOCKED or CODE UNLOCKED for the Action. In the Condition box,
press LOCKED or UNLOCKED. Next, an action must be programmed.
NOTES:
• Motorized door lock bolts physically lock and unlock when activated, but if the door lock installed
is a non-motorized type, activation allows the door to be manually unlocked without a key. See
Compatible Devices section later in this document.
• When using some older Kwikset® Smartcode electronic deadbolt door locks (in a Scene that is
programmed to trigger when unlocked) the Scene does not trigger if using a key; enter a user
code.
Set the Garage Door: Press Trigger/Condition/Action > Add .> GARAGE DOOR > Garage Door
Garage
Device, select from the drop-down menu or press Garage Door Group to activate more than one
Door
device. Select OPENED or CLOSED. The Action Menu option is OPEN or CLOSE. In CONDITIONS
OPENED or CLOSED.
NOTE: Review the disclaimer in the section Add Garage Door Module.
Set the Water Valve: Press Trigger/Condition/Action > ADD > WATER VALVE > WATER VALVE
Water
DEVICES from the drop-down menu or select Water Valve Group to activate more than one device.
Valve
The options for Trigger/Condition are OPENED or CLOSED and for Action is OPEN or CLOSE.
Set the Zones: In the TRIGGER/Condition box, press Add. Press ZONES and select a zone from the
Zones
drop-down menu. Select Restore, Alarm or Fault.
NOTE: Do not use 24-hour silent zone restore/fault in the pre-condition and trigger fields on
commercial panels.
45
Advertisement
Table of Contents
