Table of Contents
Advertisement
TUXEDO TOUCH WI-FI INSTALLATION & SETUP GUIDE
Front Panel LED's
The Tuxedo keypad has three LEDs as follows:
Mounting
Tuxedo is for indoor use within the protected area only and mounted at a comfortable viewing level. Avoid mounting in
areas of high condensation such as bathrooms or in locations where bright light or sunlight shines directly on the screen.
Tuxedo can be mounted with or without the mounting plate. Use the center securing screw for European installations.
Standard Mounting with Mounting Plate
1. Select a mounting location.
2. Detach the mounting plate by sliding downward.
3. Use the mounting plate to mark the location of the
mounting holes on the mounting surface and check
for level.
4. Locate the mounting plate over the mounting
surface such that the wire/cable access openings
are aligned while passing the wires/cable through
the case back.
**Go to Wiring and complete wiring.
5. Secure the mounting plate to mounting surface
using four screws (supplied).
6. Slide keypad onto mounting plate.
Mounting Without Mounting Plate
1. Select a mounting location.
2. Detach the mounting plate by sliding downward
and discard.
3. Use the template (provided in the carton) to mark
the location of the mounting screws and the cut-
out for the keypad assembly on the mounting
location. Check for level.
4. Install four screws (supplied) in the mounting
surface leaving screw heads 1/8" above the
mounting surface.
5. Locate the case back over the mounting surface
such that the opening is aligned with the
wire/cable access opening on the mounting surface
while passing the wires/cable through the opening
in the case back. **Go to "Wiring" and complete
wiring.
6. Mount keypad by sliding onto the screw heads.
SD/SDHC CARD Slot
ARMED (RED) LED
ON – System is armed.
OFF – System is not armed.
READY (GREEN) LED
ON – System is disarmed and ready to arm.
OFF – System is armed or disarmed but not
ready. If disarmed, faults or troubles are prese
MESSAGE (YELLOW) LED
FLASHING –The system contains new
message(s) for the Use r .
OFF – No new messages.
RESET BUTTON
Press to reset keypad
TEMPLATE
MOUNTING
SCREWS
INSTALLED
1/8" ABOVE
SURFACE
3
Advertisement
Table of Contents
