Table of Contents
Advertisement
Intouch Thermostats will not send status during a low battery condition.
•
Resideo is not responsible for property damages due to improper wiring and setting of the
thermostat modes.
Z-Wave Device Setup
Changing the Name
To change the Z-Wave device icons, do the following:
1.
Press Automation > Z-Wave Setup to display the "Z-Wave Device Management" screen.
2.
Press Z-Wave device to be edited.
3.
Press on the text box, which will produce a keypad, allowing you to edit the name. Press, "Go" when finished
saving the name.
Changing the Icon
To change the Z-Wave device icons, do the following:
1.
Press the Z-Wave device to be edited.
2.
Beneath device name, select the icon to represent the switch.
NOTES:
This applies to Binary (On/Off), Multilevel (Dimming) switches and Water Valves.
•
This is a local change only; the icons do not synchronize with Total Connect.
•
The FortrezZ® and Leak Gopher® Water valve learn in as a Water Faucet icon by default, but is changeable.
•
All other water valves may learn in as a binary switch.
All Water Valve commands are excluded from the "All Switches On/Off" command by default.
•
Changing binary switch to Water Valve also excludes it from the "All Switches On/Off" command.
•
Device Icon Options
Light
Light
Bulb
Switch
Secondary Tuxedo Note
Any device assigned to a water valve icon on the primary Tuxedo must be assigned to the same device on the secondary
Tuxedo. Failure to do so results in the water valve responding to the "All Switches On/Off command."
Garage
Sprinkler
Pool
Door
TUXEDO TOUCH WI-FI INSTALLATION & SETUP GUIDE
Water
Strobe
Faucet
38
Window
Siren
Fan
Sounder
Advertisement
Table of Contents
