Table of Contents
Advertisement
press Camera WIFI
to enter the camera wireless settings information from your router. The screen displays:
Camera Wi-Fi setup is applicable only for discovered cameras."
1.
Enter the appropriate wireless information:
• SSID: ANY
• Security Mode: Disabled, WPA personal, WPA2 personal, or WEP
• Network Type: Infrastructure
• Domain: USA
• Channel: Auto
1. For Security Mode, enter the appropriate information:
• Tx Key: 1, 2, 3 or 4; WEP Encryption: 64 bit Key (10 Hex Chars) or 128 bit Key (26 Hex Chars) , WPA and
WPA2.
• Authentication: Open System or Shared Key
• Passphrase: press GENERATE
• Key: must consist of 10 hexadecimal characters
2. Press Apply to All to set cameras for wireless operation. Press Save when done. A pop-up window displays: "Info
XXX.XXX.X.X WIFI Configuration Saved."
3. Remove the LAN cable and reboot the camera. Once rebooted, verify the can be viewed wirelessly via the Tuxedo.
If the camera does not have wireless capability, leave the camera connected to the router via the LAN connection.
4. Press Camera Settings
Advanced Camera Settings below.
NOTE: Cameras must be enrolled to access the Settings screen. If multiple cameras are enrolled, highlight the
desired camera to make changes.
Advanced Camera Settings
All features below can be changed based on the settings required. Press Camera Settings to access the following
settings.
NOTES:
• Press Save! after each selection
• Fixed Quality is not an option on the Camera Settings home screen.
Video
Feature
Resolution
Fixed Quality
Max Frame Rate
Network
Feature
Internet Connection Type
IP Address, Subnet Mask,
Default Gateway
UPNP
HTTP Port
RTSP Port
Wireless
Feature
SSID
Security System
Passphrase/ SharedKey
N/W Type
Domain
Channel
TUXEDO TOUCH WI-FI INSTALLATION & SETUP GUIDE
to enter Video, Network, Wireless, and Other settings, if required; refer to
MPEG-4, MJPEG and H.264 Settings
160x120, 320x240, 640X480
Very Low, Low, Normal, High, Very High
1-8, 10, 15, 20, 25, 30
Options
Dynamic or Static IP
Network settings (usually settings for setting up for static or a DHCP reservation
list)
Enables the discovery option in the camera when the Discover
Options are 80, 1024-65534
Real Time Streaming Protocol Port (default is 554)
Options
Network Name
Disabled, WPA Personal, WPA2 Personal
Password
Ad-hoc or Infrastructure
USA
Auto
30
"
INFO:
is pressed
Advertisement
Table of Contents
