Table of Contents
Advertisement
TUXEDO TOUCH WI-FI INSTALLATION & SETUP GUIDE
8: Voice Tutorial and Setup
Pressing Accept at the "Voice Disclaimer" prompt initiate a training video. After the training video is complete, the
keypad will walk you through three training learning objectives. These objectives are designed to introduce you to the
Voice feature. Once complete, the keypad navigates you to the Voice configuration screen. NOTE: The "Voice Setup"
screen can be access at any time, from the Home screen press Setup > VOICE SETUP.
Determines the Tuxedo response to various voice commands in different environments. The
Command
options are 1-7, where 1 is the lowest sensitivity and 7 is the highest. Use the Up and Down
Sensitivity (1-7)
arrows to change the value to the desired level.
Determines the Tuxedos response to the "Hello Tuxedo" trigger phrase. The options are 1-7,
Trigger
where 1 is the lowest sensitivity and 7 is the highest. Use the Up and Down arrows to
Sensitivity (1-7)
change the value to the desired level.
Select the Use System Volume for normal voice response volume or uncheck the box to use
Use System
the default (louder) level.
Volume
Select Enable Trigger Feedback to enable Tuxedo's voice response (optional). The
Enable Trigger
trigger phrase is, "Hello Tuxedo." The keypad displays Microphone (displayed to
Feedback
the right) and waits eight seconds for a command phrase. A message is displayed
on the screen along with a voice annunciation phrase "Hello please say your
command" if trigger feedback is enabled.
Enables or Disables the Voice Feature.
Voice On/Off
Defaults all customized Voice settings the factory defaults.
Reset to Default
Introductory and training video for the voice feature.
Voice Control
Video
Walks through the 3 steps:
Training
Lists all the "Detected Voice Commands." It provides the Date and Time of the command
Log
event.
Interprets the accuracy of the last 10 voice commands based on internal diagnostics. The optimal
Counter and
accuracy is a number between 1-2000. Example:
Troubleshooting
If needed, adjusting the "Accuracy" by entering a new value:
Press Clear to clear the last 10 counts and the last 10 accuracy level information, or press Clear
All to clear the entire list.
1. "Trigger" then "Command" training" – introduces the basic triggers and commands to
voice programming
2. "Trigger + Command" training combined – combines those trigger and commands
established in step 1.
3. "Trigger + Command" training tested five feet away – tests the trigger and command
against the environment the keypad is located in. This gives you the option to adjust the
settings as needed.
Commands
Count
19
Hello Tuxedo
5
Bed Time
2
Cameras
1
Evening Time
2
Leaving the
House
1
Returning Home
2
Wake Up
1.
Find the lowest number in the last 10 commands.
2.
Tap the Accuracy counter number column and enter a number from 1-2000 that is larger
than the lowest number shown. For example, if the lowest number shown in the history
is 599 set the counter for 800 or if the number is 8055, set it for 900.
3.
If Tuxedo continues to have trouble responding to commands, try entering a higher
number. Repeat until you achieve desirable results.
Accuracy
Last 10 Accuracy Levels
1000
3986, 4245, 233, 3085, 2178, 2158, 3099. 2869
1000
675, 1463, 285
1000
1661, 1763
100
3735
1000
3495, 4703
1000
4868
1000
1112
11
Clear
Clear
Clear
Clear
Clear
Clear
Clear
Clear
Advertisement
Table of Contents
