Power cord description
Australia 250V/10A
South Africa 250V/10A
1. Remove the projector touch panel.
2. Loosen the six screws to remove the rear cover.
3. Between the exhaust fans and the AC box assembly, disconnect the MAIN input plug from the
IN-LINE receptacle.
4. Remove the protective cap from the UPS input plug.
5. Connect the UPS input plug to the IN-LINE receptacle connector.
6. Place the protective cap from the UPS plug on the MAIN input plug.
7. Re-install the rear cover of the projector.
8. Re-install the projector touch panel.
9. Plug in the appropriate UPS power cord to the UPS and then into the UPS input (Input B) on
the projector.
Installing the lens
The lens seals the projection head, preventing contaminants from entering the main electronics area.
Caution! If not avoided, the following could result in minor or moderate injury.
•
Do not operate the product without a lens installed.
•
Always use a lens plug when installing or moving the product. This prevents contaminants from
entering the product.
1. Turn off and unplug the projector.
2. On the front of the projector, move the lens clamp to the open position.
Cinema 2K-RGB Installation and Setup Guide–CP2415-RGB and CP2420-RGB
020-103259-01 Rev. 1 (10-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Part number
108-392105-XX
108-487100-XX
Installing and setting up
23