Installing The Lens - Christie CineLife+ CP4415-RGB Installation And Setup Manual

6. Place the protective cap from the UPS plug on the MAIN input plug.
7. Re-install the rear panel of the projector.
8. Re-install the projector touch panel.
9. Plug in the appropriate UPS power cord to the UPS and then into the UPS input (Input B) on
the projector.
Related information
Accessories (on page 21)

Installing the lens

The lens seals the projection head, preventing contaminants from entering the main electronics area.
Notice. If not avoided, the following could result in property damage.
• Do not operate the product without a lens installed.
• Always use a lens plug when installing or moving the product. This prevents contaminants from
entering the product.
• Do not insert the lens into the product at an angle. This can damage the lens and the optical
components inside the product.
• Always place the lens cap onto the lens when moving the projector to avoid scratching the lens.
• Remove the lens cap before turning the product on to avoid damaging the lens.
1. Before installing the lens, ensure you turn off the projector and the circuit breaker switches.
2. Remove the lens caps from the front and rear of the lens.
Lens caps must be removed or they can melt and damage the lens.
3. Position the lens so that the UP label is facing upward.
CineLife+ 4K-RGB Installation and Setup Guide–CP4415-RGB, CP4420-RGB, CP4425-RGB, CP4435-RGB
020-103244-06 Rev. 1 (06-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
32