A
UPS circuit breaker
B
MAIN input circuit breaker
C
200-240 V main inlet
1. Loosen the six screws to remove the rear cover.
2. On the back right side of the projector, remove the four screws securing the AC receptacle
knockout plate.
The AC supply is routed to the terminal block through an appropriate strain relief mounted on
this knockout plate.
CP4415-RGB and CP4420-RGB Gen2 Installation and Setup Guide
020-103773-01 Rev. 1 (02-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
23