Table of Contents
Advertisement
ID
Port
G
Recessed button
H
USB port
I
Management port
J
Marriage button
K
Fire alarm connection
L
RS232 communication port
M
GPIO port
N
3D sync connector
HDMI video source
For the projector to accept digital video data from HDMI sources, plug the HDMI source directly into
the Video Input panel.
The input configurations listed below are supported.
Input configuration
Single-input
Dual-input
HDMI video formats
The following image formats are supported by the two HDMI inputs.
Fractional 1/1.001 frame rates, 1920 x 1080 (HD), and 3840 x 2160 (UHD) formats are also supported.
CP4415-RGB and CP4420-RGB Gen2 Installation and Setup Guide
020-103773-01 Rev. 1 (02-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Description
Select the button to transition the projector from Standby mode to
Power ON mode.
Connects to external memory device for import and export of
projector software, configuration files, and status information.
Connects to the local network and can send CineLife+ serial
commands and used for Remote UI access.
Used during the Integrated Media Block (IMB) marriage setup
process.
• Select and hold the button for 5 seconds to display the IP
address and status information.
• Select and hold the button for 30 seconds to reset the IP
address to the default address.
The marriage status LED indicator is located to the right of the
Marriage button. In full power mode, a green LED indicates the
projector is properly married and encrypted content can be
displayed. A red LED indicates marriage is broken and encrypted
content cannot be displayed.
Connects to the Theater Fire Management system for automatic
shut down in emergency situations.
Not used.
Connects the projector to external automation or automation
devices.
Connects the projector to 3D devices.
Description
Accepts connection of one HDMI cable. Supports both 2D and 3D frame-packed, top
and bottom. In this configuration, the HDMI input supplies the entire video raster.
Enables connection of two HDMI cables in support of 3D LR, where HDMI Input 1 =
left eye and HDMI Input 2 = right eye.
Video Input panel
33
Advertisement
Table of Contents
