Christie CP4415-RGB Gen2 Installation And Setup Manual page 26

A UPS input plug
B MAIN input plug
4. Remove the protective cap from the UPS input plug.
5. Connect the UPS input plug to the top power supply (A).
6. Place the protective cap from the UPS plug on the MAIN input plug.
7. Re-install the rear panel of the projector.
8. Re-install the projector touch panel.
9. Plug in the appropriate UPS power cord to the UPS and then into the UPS input (Input B) on
the projector.
Related information
Accessories (on page 16)
CP4415-RGB and CP4420-RGB Gen2 Installation and Setup Guide
020-103773-01 Rev. 1 (02-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
26