Digi Connect IT 4 User Manual page 41

Configure Connect IT using the web user interface
Setting
Match IMSI
Match ICCID
PIN
Phone Number
Roaming
Use DNS
SIM failover
Connection attempts before
SIM failover
Digi Connect IT® 4 User Guide
Configure the modem in the Connect IT
Description
This conditional field displays when the IMSI option is
selected from the Match SIM by list box.
Enter the IMSI (International Mobile Subscriber Identity)
match criteria. The interface is applied when the SIM card
has this IMSI.
This conditional field displays when the ICCID option is
selected from the Match SIM by list box.
Enter the ICCID (Integrated Circuit Card Identifier) match
criteria. The interface is applied when the SIM card has this
ICCID.
The PIN required to unlock the SIM card. Leave blank if not
PIN is required.
The phone number stored on the SIM card will be
automatically reported to enable SMS services. If the SIM is
not provisioned with a phone number, or it contains an
incorrect phone number, it will be necessary to complete this
field with the correct phone number to reach this device.
In normal operation, this field should be blank.
Enable roaming to allow connections to data services outside
of the original country of the SIM. When enabled, the cost of
data use may increase significantly.
Specify when this interface's DNS servers will be used.
Always: Always use the DNS servers provided for this
n
interface. If multiple interfaces have the same DNS
server, requests to the DNS server will be routed
through the interface with the lowest metric.
When primary default route: Use the DNS servers
n
provided for this interface only when the interface is
the primary default route. This is the default.
Never: Never use the DNS servers provided for this
n
interface.
Enable SIM failover to automatically switch the active SIM
slot to the next available SIM if the modem interface fails to
connect.
The number of unsuccessful connection attempts before
switching to the next SIM slot.
Minimum value: 1
The default value is 5.
41