Table of Contents
Advertisement
Configure Connect IT using the web user interface
1.
Log in to the Connect IT web
2. Click Configuration in the left pane.
3. Expand the System section.
4. Enter values into the fields.
Field
Name
Contact
Location
Banner
5. Click Save at the bottom of the screen to save the changes.
Configure VPN from the web UI
Configure an IPsec tunnel for a VPN from the web UI
You can configure an IPsec tunnel for a VPN.
1.
Log in to the Connect IT web
2. Click Configuration in the left pane.
3. Expand the VPN section.
4. Expand the IPsec section.
5. Set the NAT keep alive time.
a. Expand the advanced section.
b. In the NAT keep alive time field, enter the length of time to keep NAT alive for
6. Create an IPsec tunnel.
a. Expand the Tunnels section.
b. In the Add IPsec tunnel field, enter a name for the tunnel.
c. Click Add.
d. The tunnel is enabled by default. Verify that the Enable option is selected.
e. Complete the fields in each of the sections. To display information about what you
7. Click Save at the bottom of the screen to save the changes.
Digi Connect IT® 4 User Guide
UI.
Description
The name for the Connect IT. This name displays in prompts and
log messages.
Contact information for this Connect IT.
A description of the Connect IT's physical location
A banner message that displays when a user accesses terminal
services on this device.
UI.
IPSEC tunnels. the default is 40 seconds. The syntax for the entry is number
{w|d|h|m|s}.
should enter in each field, click the down arrow and then Help next to each field.
Configure VPN from the web UI
48
Advertisement
Table of Contents
