Table of Contents
Advertisement
Configure Connect IT using the web user interface
Setting
Ancillary gateway
Ancillary DNS redirect
6. Click Save.
Configure a custom gateway for the modem
You can configure a custom gateway/netmask that overrides the automatic values normally provided.
This is particularly useful when supporting a group of static UP addresses that communicate directly.
1.
Log in to the Connect IT web
2. Click Configuration in the left pane.
3. Expand the Modem section.
4. Expand the Custom gateway section.
5. Configure the settings.
Setting
Enable
Gateway/Netmask
6. Click Save.
Configure an IPv4 network interface for the modem
You can configure an IPv4 network interface.
1.
Log in to the Connect IT web
2. Click Configuration in the left pane.
3. Expand the Modem section.
4. Expand the IPv4 section.
5. Configure the settings.
Digi Connect IT® 4 User Guide
Description
When the passthrough modem is not connected, the
ancillary gateway will be provided to clients to allow
functional local networking.
Syntax: IPv4_address/netmask
Default: 10.0.0.1
When the passthrough modem is not connected, the
ancillary gateway will resolve all DNS requests to
itself. HTTP traffic will be redirected to the device's
web administration page.
UI.
Description
Select Enable to enable a custom gateway for this
network interface.
The gateway address and netmask to use for this
network interface. If either the gateway address or
the netmaks is all 0's, it is not overridden. For
example, 0.0.0.0/32 will operate as normal using the
network-provided gateway IP, but with a /32
netmask.
UI.
Configure the modem in the Connect IT
44
Advertisement
Table of Contents
