Table of Contents
Advertisement
Configure Connect IT using the web user interface
Log in to the Connect IT web UI
To be able to access the web UI, your PC and the Connect IT must be connected by an Ethernet cable.
1. Connect your PC to the Connect IT with an Ethernet cable.
a. Connect one end of an Ethernet cable to your computer.
b. Connect the other end of the Ethernet cable to the LAN Ethernet port on the 4.
2. Open a web browser on your PC.
3. Type in the IP address for the Connect IT: 192.168.210.1
4. Press Enter. The login screen displays.
5. Enter the user name and password:
User Name: The default user name is: root
n
Password: The default password for the Connect IT is printed on the label attached to
n
the device. Once you are logged in you can
6. Click Log in. The Connect IT web user interface appears.
Manage users, groups, password, and two-factor authentication
from the web UI
You can manage the root user, add groups, and configure two-factor authentication.
Configure idle timeout from the web UI
You can configure the length of time after which users are disconnected from services. If you do not
enter a value, the idle timeouts feature is disabled, and the user will not be disconnected from
services.
1.
Log in to the Connect IT web
2. Click Configuration in the left pane.
3. Expand the Authentication section.
4. In the Idle timeout field, enter the length of time after which users are disconnected from
services. Leave this field blank to disable this feature.
Syntax: number{w|d|h|m|s}
5. Click Save at the bottom of the screen to save the changes.
Digi Connect IT® 4 User Guide
change the
UI.
Log in to the Connect IT web UI
password.
27
Advertisement
Table of Contents
