Setting up Digi Connect ES Device Server
hardware
Setting up Digi Connect ES Device Server hardware consists of connecting power to the device,
connecting the device to the network, connecting Ethernet devices, and connecting serial devices.
Before setting up the hardware
CAUTION! It is the installer's responsibility to ensure that this device is installed and put into
EMC specification
The customer or the user of the Digi Connect ES should assure that the device is used in an
environment that meets EMC specifications.
Emissions test
RF emissions
CISPR 11
Digi Connect ES Device Server Hardware setup guide
service according to the EMC specifications below.
Guidance and manufacturer's declaration - electromagnetic emissions
Compliance
Group 1
Electromagnetic environment-guidance
The Connect ES uses RF energy only for its internal
function. Therefore, its RF emissions are very low
and are not likely to cause any interference in
nearby electronic equipment.
11