Connect Hardware And Connect To A Cellular Network - Digi Connect IT 16 User Manual

Get started with Connect IT 16/48
4. Connect the other end of the Ethernet cable to the Ethernet ETH2 port on the 16/48. By
default a DHCP request will be sent to the local Ethernet network.

Connect hardware and connect to a cellular network

This section explains how to connect the Connect IT hardware and then connect to a cellular network,
using a CORE module. You must have purchased a CORE module to be able to connect to the cellular
network.
Note As an alternative, you can also use an Ethernet LAN connection. See
connect to site network using an Ethernet
To connect the hardware and connect to the cellular network:
1. Insert a CORE module with an activated SIM card. See
2. Plug the power supply cord into at least one of the power supplies on the back of the device.
The second power cord can also be plugged in, but it is not required. It is available for power
redundancy.
3. Plug the power supply unit into an AC power outlet to power up the Connect IT 16/48.
Digi Connect IT® 16/48 User Guide
LAN.
Cellular ONLY: Insert the CORE
Connect the hardware
Connect hardware and
module.
13