Extron electronics NAV 10SD 101 User Manual page 68

NOTE: IP Address, Subnet, Gateway, DNS Server, and DNS Suffix are not editable
when is on.
DHCP
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
A A A A A A A A A A A A A A A A A A
B B B B B B B B B B B B B B B B B B
*
5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5
6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6
DHCP On
* NAV 10SD 501 only
Figure 61. Editable Network Connection Selection
1
DHCP — Click to toggle
automatically receives network configuration parameters from a DHCP server. If no
DHCP server is available, the endpoint remains on Link local IP (see
2 IP Address, Subnet, and Gateway — Click in these fields and type in values to enter
the appropriate connection values for your decoder.
3
DNS (Domain Name System) Server — Click in this field and type in the name of the
domain name server.
4 DNS suffix — Click in this field and type the valid domain name suffix of the domain
name server.
5 Ethernet Extension — Click to toggle the rear panel Extension port (see
on page 6) on and off.
6 SAVE and CANCEL buttons — Click SAVE to take Network Connection changes or
CANCEL to abandon them. Clicking either button closes the editable pane.
NOTES:
• Link Local ( A
) — DHCP is on by default. When a DHCP server is not
accessible, the Link local IP Address, an address in the range of 169.254.1.0 to
169.254.254.255, is assigned to the endpoint when no other address assignment
methods are available.
B
• MAC Address ( ) — A unique read-only identifier for network connected devices.
NAV 10SD 501 and NAV 10SD 101 Scaling Decoders • HTML Operation
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3
4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4
A A A A A A A A A A A A A A A A A A
B B B B B B B B B B B B B B B B B B
*
5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5
6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6
DHCP Off
on and off. When DHCP is enabled, the endpoint
DHCP
).
A
figure 2,
F
60