Extron electronics NAV 10SD 101 User Manual page 64

Username/Password page
The Username/Password selection on the General Settings page (see
page 51) opens a read-only pane that shows the credentials of the decoder (see figure 55).
The Password can be edited by clicking the EDIT button (
selection opens (see figure 56).
NOTES:
Editing of these settings is disabled and the EDIT button is unavailable for selection
•
when the decoder is assigned to a NAVigator.
•
Any devices assigned to the NAVigator inherit the password of that NAVigator.
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
Figure 55. Username/Password Selection
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
Figure 56. A A A A A A A A A A A A A A A A A A Editable Username/Password Selection
1
Password and Confirm Password — Click in these fields and type in valid password
values to enter the appropriate values for your decoder.
NOTES:
•
A valid password meets the following requirements:
• The length is up to 64 characters.
• All alphanumeric characters and ASCII symbols are permitted except |
(pipe).
• The password cannot be blank.
• The password cannot start with a space.
• The factory configured passwords for all accounts on this device have been
set to the device serial number. In the event of a complete system reset, the
passwords revert to the default.
• The default username is
TIP: Select (click) the Show Password checkbox (
you type it.
2 SAVE and CANCEL buttons — Click SAVE to take Password change or CANCEL to
abandon it. Clicking either button closes the editable selection.
NAV 10SD 501 and NAV 10SD 101 Scaling Decoders • HTML Operation
1 ). An editable version of the
and the default password is
admin
A ) to display the password as
figure 48 on
.
extron
56