Audio Pane - Extron electronics NAV 10SD 101 User Manual

3 Color Bit Depth (see figure 16
drop-down list to select between the following two output
formats for the HDMI Output port (see
• Auto — Adjusts color bit depth based on the display EDID
(10 bit or 8 bit) (default).
Force 8-Bit — Always uses 8 bit output.
•
4 HDCP Notification — Click to toggle HDCP Notification on and off. This selection
lets you select what is displayed on the HDMI output when the input signal contains
HDCP-protected content and the output is a non-HDCP sink.
When HDCP Notification is checked, a green screen is generated to clearly indicate
an HDCP issue has been encountered. When HDCP Notification is unchecked, a
black screen is generated to discretely show there is an HDCP issue.
This feature has no effect on the functionality of HDCP. Extron recommends leaving
HDCP Notification enabled to easily know when a HDCP issue has occurred.

Audio pane

See figure 17. If you change any of the settings in the Audio dialog box (
SAVE button (
3 ) becomes selectable. Click SAVE to take changes or CANCEL (
abandon them. Clicking either button closes the dialog box.
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3
Figure 17. Audio Dialog Box
1 Audio Volume — Set the
• Click and drag the fader control.
• Click the and
Directly type a rate into the field.
•
2 Allow Audio Only — Click to toggle Audio Only on and off.
NOTES:
• Audio Only sends a black video signal and sync to the attached display to
prevent it from going into a standby state. This allows audio to continue to be
played using the internal speakers of the display when there is no video.
Allow Audio Only must be disabled to use the NAV screen saver (see
•
Screen Display (OSD) pane
NAV 10SD 501 and NAV 10SD 101 Scaling Decoders • HTML Operation
on page 25) — Click the
B
on page 7).
4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4
Volume in one of three ways:
Audio
buttons.
on page 30).
1 2
and ), the
4 ) to
On
26